Im trying to install a horn on my 48, CJ2A, it has a horn button allready in the center of of steering wheel,steering column is just a hollow tube with signalstat external turn signal controller, there is a wire [ ground] going down the inside of steering column but this wire is cut off at a couple of inches down into the column [tube]. the steering wheel makes allmost 2 full revolutions from stop to stop, so if I run the wire out the bottom of column it will wind around the steering shaft where it comes out at the bottom in the engine compartment. I could probably put enough slack in the wire to allow for this,but that doe'snt seem like the way to do it, I also have an external horn button I could install on the outside of the column or on the dash, but it has a horn button already installed in steering wheel, so it seems like there should be a way to use it, I just have'nt figured it out yet. any suggestions, thanks