-
Brake pedal arm issues
Just installed a new dual master cylinder kit from KW, and at the same time replaced the brake pedal arm which had wallowed out from years of service.
Problem is these new arms are straight without the offset designed into the old original arm. Without the offset "jog" the new arm hits the new master cylinder when depressed.
The question is has anyone run into this? Can this arm be heated and safely bent. It appears to be cast but I'm not sure if it is cast steel or cast iron.
Thanks
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules