cylinder head question - Never saw this before

[jeep_n_john]

Bmorgil is our resident all-around guru of just about everything! The non-foulers used to be found on a lot of gas-powered auction equipment. Our 2A had them on three of the four cylinders before it was repaired. Along with the non-foulers, it was also running two cycle chain saw plugs. Needless to say, there would be no mosquitos within a mile of the Heep running.

This is hilareous, The subject head from my spare motor has the non-foulers on 3 of 4 cylinders and also has 2-cycle chain saw plugs!! Did I end up with your ole engine????

[gmwillys]

John,

No such luck. I still have the same engine in our Heep that was in it when it was purchased. My Granddad had it for a while for use on their farm, and he went through and replaced the one piston that had a hole in it, then freshened up the bearings and rings. He didn't believe in spending more than one had to perform repairs. He passed in 2003, so it was done some time in 2001 or early 2002, but it has been smoke free ever since.