Results 1 to 2 of 2

Thread: The Correct Grease for the "Zerks"

  1. #1
    Super Moderator bmorgil's Avatar
    Join Date
    Dec 2018
    Location
    Northwestern Ohio
    Posts
    3,805

    The Correct Grease for the "Zerks"

    The "Zerk Lube" has two categories.

    1) Zerk's that need High temp, E.P grease. (U-Joints and Wheel Bearings) "Spicer U-Joints" and all Wheel bearings require an NLGI grade 2 grease. I use Chevron Ultra Duty NLGI 2 EP Grease. We tested it severely on the U-Joints. It was the best we could find.

    2) Those Zerk's that can use anything (Low Temp, Chassis Lube) The Chassis points do not require High Temp or E.P.. Here a NLGI Grade 0 or 1 will work. I like NLGI 1 because it is thicker and stays put. I like a good name NLGI grade 1 White lithium.

    The study of grease can be mind boggling and misleading. For instance the Universal Service Manual calls for the wrong grease in the U-Joints. U-Joints MUST have an EP additive. This is probably a miss print or, left over from long ago.I can show you what a U-Joint looks like when you use the wrong stuff. I also found several spots on the Internet with incorrect information. No matter what you read I can assure you I spent many years promoting NLGI Grade 2 EP ONLY in Spicer U-Joints. The most common cause of failure in a U-Joint is "Lack Of Lube". The second most common is "Wrong Lube".

    Many manufactures specify different greases for different reasons. There is a lot of stuff written that's for sure! Sticking to the above will keep all out of trouble.

    Maybe this one clarification will save a U-Joint.

  2. #2
    Super Moderator bmorgil's Avatar
    Join Date
    Dec 2018
    Location
    Northwestern Ohio
    Posts
    3,805
    Don't forget the rears!

    Last edited by bmorgil; 05-24-2024 at 08:35 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •